Product ID:MIL-C-22750 E #16081 GREY, P/N M8-091
MSDS Date:04/20/1994
FSC:8010
NIIN:01-350-2073
Kit Part:Y
MSDS Number: BVGTF

CRAWFORD LABS, INC

4165 S EMERALD AVE
CHICAGO, IL 60609
US

Emergency Phone: 312-433-1307

Info Phone: 312-376-7132

Preparer: DAVID SCHMETTERER

Cage: 5V430

CRAWFORD LABORATORIES, INC

CHICAGO, IL 60609 US

Telephone: 312-376-7132

Cage: 5V430

METHYL ETHYL KETONE (SARA III) (VAPOR PRESSURE 71.2 MM HG)

CAS: 78-93-3

RTECS: EL6475000

Fraction By Weight: 13%

OSHA PEL 100 PPM

ACGIH TLV: 200 PPM

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

REACTION PRODUCTS OF EPICHLOROHYDRIN & BISPHENOL A

CAS: 25085-99-8

Fraction By Weight: 19%

TOLUENE (SARA III) (VAPOR PRESSURE 38 MM HG)

CAS: 108-88-3

RTECS: XS5250000

Fraction By Weight: 8.2%

OSHA PEL 100 PPM

ACGIH TLV: 100 PPM;STEL 150 PPM

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

100 SOLVENT (VAPOR PRESSURE 9. MM HG)

CAS: 64742-95-6

Fraction By Weight: 1.3%

OSHA PEL 50 PPM

ACGIH TLV: 50 PPM

TITANIUM OXIDE

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 17%

ACGIH TLV: 10 MG/M3

AMORPHOUS SILICA (TITANIUM OXIDE CONTAINS 1-10% AMORPHOUS

CAS: 112926-00-8

RTECS: VV8850000

ALUMINIUM HYDROXIDE (TITANIUM OXIDE CONTAINS 0-9% ALUMINUM

CAS: 21645-51-2

RTECS: BD0940000

SILICON DIOXIDE (CRYSTALLINE)

CAS: 14808-60-7

RTECS: VV7330000

Fraction By Weight: 8.2%

OSHA PEL 0.1 MG/M3

ACGIH TLV: 0.1 MG/M3

Reports of Carcinogenicity:NTP:UNKNOWN IARC:YES
Health Hazards Acute and Chronic:OVEREXPOSURE MAY PRODUCE VARIOUS
EFFECTS, INCLUDING: ACUTE TOXICITY (HEADACHE, DIZZINESS, NAUSEA,
UNCONSCIOUSNESS). SEVERE EYE IRRITATION (MAY BE PERMANENT DAMAGE).
IRRITATED MUCOUS MEMBRANES. VOMITIN G DUE TO INGESTION. DEFATTING &
DRYING OF SKIN. SENSITIZATION AFTER REPEATED CONTACT.
Explanation of Carcinogenicity:IARC HAS CONCLUDED THAT THERE IS LIMITED
EVIDENCE FOR THE CARCINOGENICITY OF CRYSTALINE SILICA TO HUMANS.

First Aid:NOTHING BY MOUTH TO UNCONSCIOUS. EYE:FLUSH W/WTR 15 MIN,LIFT
EYELID.GET MED AID.INHAL:MOVE TO FRESH AIR.GIVE OXYGEN IF BREATH
DIFFICLT,ARTIF RESP IF NO BREATH.GET MED AID.KEEP WARM &
COMFORTABLE.INGES T:CALL DR IMMED.INDUCE VOMIT ON DR'S
INSTRUCTIONS.IF VOMIT OCCURS,KEEP HEAD BELOW HIPS.SKIN:FLUSH
W/WATER WHILE REMOVING CONTAM CLOTH/SHOES.THEN WASH W/SOAP &
WATER.IF IRRITATION PERSISTS,GET MED AID.

Flash Point Method:SCC
Flash Point:28.0F,-2.2C
Lower Limits:0.9
Extinguishing Media:FOAM, CO2, OR DRY CHEMICAL
Fire Fighting Procedures:WATER MAY BE USED TO KEEP EXPOSED CONTAINER
COOL & KEEP FLAMMBL STRUCTURE WET.DON'T ENTER FIRE AREA W/OUT
PROTECTN BECAUSE HAZARD DECOMP PRODUCT MAY BE PRESENT.
Unusual Fire/Explosion Hazard:WATER PRESSURE MAY SPREAD A FLAMMABLE
LIQUID FIRE. SEALED CONTAINERS MAY EXPLODE IF OVERHEATED.

Spill Release Procedures:WARNING - FLAMMABLE. ELIMINATE ALL IGNITION
SOURCES. HANDLING EQUIPMENT MUST BE GROUNDED TO PREVENT SPARKING.
SOAK UP WITH AN ABSORBENT AND PLACE IN NON-LEAKING CONTAINERS. SEAL
TIGHTLY FOR PROPER DIS POSAL.

Handling and Storage Precautions:FLAMMABLE. KNOW DOT REGS BEFORE
TRANSFERRING. WARNING: HOT ORGANIC CHEMICAL VAPOR/MIST SUSCEPTIBLE
TO SUDDEN SPONTANEOUS COMBUSITON WHEN MIXED W/AIR.
Other Precautions:IGNITION MAY OCCUR AT TEMPS TEMPS. IGNIT TEMPS DECREASE W/INCREASING VAPOR VOLUME & AIR CONTACT
TIME & ARE INFLUENCED BY PRESSURE CHANGE. IGNITION MAY OCCUR AT
TYPICAL ELEVATED TEM P PROCESS CONDITIONS, ESPECIALLY IN *

Respiratory Protection:IMPORTANT - MUST PROVIDE ADEQUATE VENT TO
MAINTAIN CONCENTRATIONS BELOW THE ESTABLISHED TLV LIMIT AS GIVEN BY
OSHA. IN MORE CONFINED AREAS A NIOSH/MSHA APPROVED RESPIRATOR
EQUIPPED WITH ORGANIC VAPOR CARTRIDGE SHOULD BE WORN.
Ventilation:MUST PROVIDE ADEQUATE VENTILATION (SEE RESPIRATORY
PROTECTION INFORMATION)
Protective Gloves:USE RUBBER GLOVES
Eye Protection:WEAR APPROVED SAFETY GOGGLES/FACE SHIELD
Other Protective Equipment:HAVE EYE BATH AND SAFETY SHOWER AVAILABLE.
Work Hygienic Practices:DO NOT REUSE COMTAMINATED CLOTHING OR SHOES.
Supplemental Safety and Health
* PRECAUTIONS CONT'D: PROCESS OEPRATING UNDER VACUUM IF SUBJECTED TO
SUDDEN INGRESS OF AIR, OR OUTSIDE PROCESS EQUIPMENT OPERATING UNDER
ELEVATED PRESSURE IF SUDDEN ESCAPE OF VAPOR OR MIST TO ATMOSPHE RE
OCCURS. ANY PROPOSED USE OF THIS PRODUCT IN ELEVATED TEMPERATURES
PROCESSES SHOULD BE THOROUGHLY EVALUATED FOR SAFETY

HCC:F2
Boiling Pt:B.P. Text:174 TO 344F
Vapor Density:> AIR
Spec Gravity:1.32
Viscosity:71 KU
Evaporation Rate & Reference:3.44 X N-BU AC
Solubility in Water:SLIGHT
Appearance and Odor:GREY LIQUID, SOLVENT ODOR
Percent Volatiles by Volume:35.9
Corrosion Rate:NOT CORR

Stability Indicator/Materials to Avoid:YES
MAY BE INCOMPATIBLE WITH OXIDIZING AGENTS AND STRONG ALKALIES.
Stability Condition to Avoid:AVOID HEAT, SPARKS, OPEN FLAMES
Hazardous Decomposition Products:INCOMPLETE COMBUSTION FOR PRODUCTS
LIKE THIS MAY GENERATE HIGHLY POISONOUS CARBON MONOIXDE AND OTHER
TOXIC GASES.

Waste Disposal Methods:DISPOSAL MUST BE IN ACCORDANCE WITH CURRENT
LOCAL, STATE, AND FEDERAL REGULATIONS. CONTACT AN APPROVED DISPOSAL
FACILITY. EPA HAZARDOUS WASTE CODE: D001, IGNITABLE.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.